Oki B8300 Bedienungsanleitung PDF herunterladen (Seite 55)

Key operator programs — 54

Key operator code change

This program is used to change the key

operator code.

The key operator must register a key operator

code number and use this number to gain

access to key operator programs. Only one key

operator code number can be registered.

The factory has registered five zeros (00000) as

the code number to allow initial access to the

programs. It is recommended that the key

operator use the factory number for initial entry

into the programs and then change the number

using the program

Default settings

These programs are used to adjust the settings

of various printer functions from the factory

default settings or to cancel the settings.

Print density level

This program is used to adjust the lightness or

darkness of prints. The print density level can

be selected from the following options:

LIGHTEST

LIGHTER

NORMAL

DARKER

DARKEST

Disable notice page printing

This program is used to disable notice page

printing.

Disable test page printing

This program is used to disable test page

printing. If this program is set, printer test page

printing using custom settings cannot be

executed.

A4/LT auto select

If this program is set, and printing on to

Letter (8½"

x 11") size paper is selected but not

available, the printer will automatically

substitute A4 size paper in place of Letter if A4

paper is available.

Letter size paper cannot be automatically

selected in place of A4.

Interface settings

These programs are used to control data

transmitted to the parallel port or network port

of this printer.

Hexadecimal dump mode

This program is used to output the print data

from a computer in the hexadecimal dump

format with corresponding characters (ASCII).

This program is used to check proper

transmission of print data from the computer to

the printer.

Output example of hexadecimal dump mode

(A4 portrait)

PDL for parallel port

This program is used to specify a printer

language to emulate when the printer is

connected to a computer through a parallel port.

> It is recommended to leave the default

setting at AUTO (unless an error due to

this setting occurs frequently.

PDL for network port

This program is used to specify a printer

language to emulate when the printer is

connected to a computer through the network

port. The setting items are the same as those of

PDL for parallel port.

> It is recommended to leave the default

setting at AUTO (unless an error due to

this setting occurs frequently.

Setting item Description

Auto The printer language will switch

automatically in accordance

with data from the computer.

PostScript PostScript is used to print the

data from the computer.

PCL PCL is used to print the data

from the computer.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 94 95

Kommentare zu diesen Handbüchern

Keine Kommentare